Sweep & inspection
Caps & crowns
Flue relining
Masonry repair
Gas fireplace serviceLevel 1 sweep and inspection to the NFPA 211 annual standard - flue, crown, cap, and flashing checked and photographed
Chimney sweep logs do not sweep chimneys. They loosen some creosote - which then falls where a brush and vacuum still have to collect it.
Fast, Reliable Chimney Cap & Crown Across Frankford
If your chimney crown is cracked or your cap has gone missing, you’re in the right place. Chimney cap and crown work in Frankford usually runs $340 – $1,150 depending on whether we’re coating a crown, rebuilding one, or fitting a multi-flue cap on a shared stack. We work Frankford’s rowhouse blocks and twins constantly, and we know what these older stacks look like before we climb them. One call to (855) 259-0792 covers the diagnosis, the cap and crown work, and any liner question that shows up along the way.

Why Frankford Homeowners Call Chimney Sweep Oxford Circle for Chimney Cap & Crown
Frankford is one of those neighborhoods where the chimneys tell you the history of the block. Walking the numbered side streets, you’ll see whole runs of twins sharing a single chimney wall, and that changes the job. A cracked crown at one address almost always turns up as water intrusion and draft complaints at the neighboring twin. We diagnose both sides at once, because fixing one crown and ignoring the shared wall just moves the problem next door.
Our technicians have up to 9 years of experience and work chimneys and fireplaces exclusively, which means faster diagnosis and no second contractor when a cap call turns into a crown rebuild. We use Gelco and Famco caps engineered for weather performance, and we source from Olympia Chimney and Copperfield, so the parts going on your stack are professional-tier, not big-box substitutes. Every recommendation gets backed by camera footage you watch before you agree to anything.
Styles & brands we work with
- Sweep & inspection
- Caps & crowns
- Flue relining
- Masonry repair
- Gas fireplace service
Our Chimney Cap & Crown Services in Frankford
Cap Installation in Frankford
An exposed exterior stack in Frankford takes rain straight down an unlined flue if the cap is missing. We fit the right cap for the flue count and appliance setup, sized so it vents properly and keeps animals and Nor’easter rain out. On a gas appliance sharing the stack, that sizing matters more than the cap’s looks.
Cap Replacement in Frankford
Plenty of Frankford caps were sold off a rooftop glance and were never right for the flue. When we replace a cap, we measure the flue, check the crown and spalling brick first, and tell you plainly whether a cap alone actually solves it or whether the crown is the real culprit.
Crown Repair in Frankford
Frankford’s freeze-thaw cycles crack original clay crowns, and once water gets in it runs down the flue and into the brick. We rebuild failed crowns with proper slope and overhang so water sheds away from the stack instead of into it. The repair is built to last, not patched to pass.
Crown Coating in Frankford
Not every crown needs a rebuild. Where the damage is surface-level, we resurface with HeatShield, a code-compliant repair system, which seals deterioration without tearing off sound masonry. We’ll show you the footage and tell you which option your crown actually calls for.
Multi-Flue Cap in Frankford
Original Frankford stock often retains former coal or oil flues now serving gas appliances, which means two flues on one stack. A single multi-flue cap covers both openings and vents them correctly. This is the setup most shared-twin addresses need.
Custom Cap in Frankford
Odd stack sizes and unusual flue arrangements on older Frankford homes don’t fit a stock cap. We have custom caps fabricated to the exact dimensions so the fit is right and the weather stays out.
Trusted Brands We Service in Frankford
We work with professional-grade brands because the parts hold up. Our caps come from Gelco and Famco, engineered for weather performance and longevity. We source from Olympia Chimney and Copperfield, two of the chimney industry’s most trusted wholesale suppliers. When a crown call reveals a liner problem, we install DuraFlex flexible liner systems and resurface with HeatShield. One call covers sweep, inspection, repair, and material sourcing, so you’re never handed off to a second company. From the firebox to the crown, it’s one trade, done by technicians who work chimneys exclusively.

See the difference
Before
After
Before
After
Before
AfterCommon Chimney Cap & Crown Problems We See in Frankford Homes
- Cracked clay-tile crowns on pre-war rowhouses. Freeze-thaw cycles open cracks that let water run down an unlined coal-era flue now serving a gas appliance. By the time you see a damp stain near the chimney breast, the crown has been failing a while.
- Missing or undersized caps on exposed exterior stacks. Rain and nesting animals get into the flue, and the moisture and draft complaints usually show up at the adjacent twin as well. These blocks share chimney walls, so both sides get checked.
- Rooftop-glance cap sales that miss the real problem. An aftermarket cap doesn’t fix spalling brick and a failed crown. We diagnose with camera evidence so you’re not paying for a cap when the crown is the issue.
- Spalling brick at the exposed stack. Philadelphia’s humid summers and freezing winters drive this hard on older Frankford brick. The brick face flakes, moisture gets in, and the repair needs to address the cause, not just the surface.
On Frankford’s early-1900s brick rowhouses, a typical cap-and-crown call starts with a homeowner noticing a damp stain near the chimney breast or a smoky smell in humid weather. Up top, the pro finds an original clay-tile or unlined flue, a crown cracked from freeze-thaw cycles, and spalling brick at the exposed stack, sometimes with a rusted or missing cap letting rain straight into the flue. The usual fix is a camera-documented crown rebuild or coating plus a correctly sized cap, with any liner recommendation backed by footage the homeowner watches before agreeing to anything.
Pricing for Chimney Cap & Crown in Frankford, PA
These are typical Frankford estimates, and the written estimate sets the final price. A standard single-flue cap installation runs $340 – $575. A multi-flue or custom cap for a shared twin stack runs $575 – $1,150. Crown coating runs $450 – $800, and a full crown rebuild runs $800 – $1,500 depending on the stack size and how much spalling brick needs attention. What moves the price: the number of flues, the crown’s condition, access on a low-pitched roof, and whether a liner problem turns up during inspection. You see the camera footage and a flat-price scope before booking. Nothing is recommended without evidence you can check yourself, and we’ll tell you plainly when work can safely wait.
We Also Serve Cities Near Frankford
We work Frankford and the surrounding neighborhoods, including Oxford Circle, Tacony, Mayfair, and Fox Chase. Same older housing stock, same twin-shared stacks, same freeze-thaw crown problems. If you’re just across the Torresdale corridor, the diagnosis and the fix are the same, and one call covers it.
Serving Frankford, PA – Our Local Coverage Area
We serve Frankford and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
FAQs – Chimney Cap & Crown in Frankford
It likely needs both, but we won’t tell you which until we’ve run a camera. An old coal flue repurposed for a gas appliance was never sized for it, so a cap and crown fix the water and weather side while the liner question is separate. We diagnose during your sweep and show you the footage before recommending anything. Call (855) 259-0792 for an exact quote – estimates are free.
Yes. On shared-twin chimney walls, a cracked crown next door routinely drives water intrusion and draft complaints on your side. We diagnose both addresses at once so the fix addresses the shared wall, not just one half. Call (855) 259-0792 for an exact quote – estimates are free.
Crown coating seals surface-level deterioration, while crown repair rebuilds a crown that’s structurally failed. On original 1900s brick stacks, the camera tells us which your crown actually calls for. We don’t coat a crown that needs a rebuild. Call (855) 259-0792 for an exact quote – estimates are free.
Sometimes. In Frankford’s dense rowhouse blocks, smoke and draft problems are often influenced by neighboring stack heights, and a properly sized or taller cap can change the draw. We check both stacks before recommending anything, so you’re not paying for a cap that won’t solve it. Call (855) 259-0792 for an exact quote – estimates are free.
Once a year is the standard, and older Frankford clay-tile flues especially benefit from an annual look. Freeze-thaw cycles and humid off-season air work on these stacks year round, so an annual inspection catches a failing crown before it becomes water damage. Call (855) 259-0792 for an exact quote – estimates are free.
If your Frankford chimney crown is cracked, your cap is missing, or you’re not sure whether a cap alone will fix it, call us at (855) 259-0792 for a free estimate. We answer 24/7, and fast dispatch runs 7am-7pm, Sunday through Friday. Nothing gets recommended until you’ve seen the camera evidence yourself. We’ll tell you straight whether a cap, a crown rebuild, or a liner is the real answer, and when work can safely wait.
Written by the team at Chimney Sweep Oxford Circle.